I upgraded VSC 4.2 to VSC 4.2.1 and now I receive the following error when trying te edit, run or add backup jobs:
I previously did not have any specific roles set up, and all worked fine.
I have now tried adding these permissions following NetApp's KB (https://kb.netapp.com/support/index?page=content&id=1013627), but this does not resolve the issue.
I have not tried adding rights to ONTAP, since I don't have the required access to the system, I would have to ask a colleague.
What could be causing this? I have never had this with previous versions..
I'm an Escalation Engineer here at NetApp in the Global Support Organization, and wanted to reach out to everyone encountering this issue to ensure that you've opened support requests if you're encountering this issue, to ensure that we're remediating any of the issues within the software (whether it's this permissions issue or another problem/complaint). Once you've opened a support request for the VSC issues, please send me a PM with the support case number to ensure that we get the case escalated as quickly as possible.
I'm in the same situation. 'Failed to determine priviliges for operation: xxxx'.
It's a strange issue, because jobs that were created last week are still working ok, but I can't edit or add new ones.
The scenario is a new fresh install on vCenter 5.5 with ESXi 5.5 on hosts (No early versions of VCS were installed) . One server is running vcenter service & inventory service, and in other server is running Single-SignOn service, Webclient service and VCS 4.2.1 service.
I'm afraid that I can not go back to 4.2 because is not supported for vSphere 5.5.
Any comment wil be appreciated.
This appears to be an upgrade/permissions issue, we've been able to confirm that the following action plan works to resolve the message in VSC 4.2.1:
If you continue to see permissions issues, please don't hesitate to open a support case with NetApp Support.
Schrie, I too had this issue and have followed your instructions but now when I go to see if the issue with the backup job is still there I have found that all my backup jobs no longer exist as well as all my backups which have now disappeared? I assume this was not the intended result from your instructions to reinstall VSC? Please advise as a matter of urgency as I am worried that all my backups are gone for good?! I have a Netapp case already for this issue.
Thanks Ismael for your response. Glad to hear it worked for you and that you it still maintained your backups and backup jobs. Luckily, I took a vmware snapshot of my vcenter server vm and reverted back to it and got all my backups back. Strange thing is that after i reverted back to my snapshot and I rebooted server, I found that I no longer received this error message and I could edit the backup job again?!? Very strange! I still dont trust v4.2.1 though, I think it is buggy! I have a case with netapp who are suggesting that I revert back to v4.2. Will keep you posted!