2 Replies Latest reply: Mar 28, 2013 12:01 PM by scottgelb RSS

Backup Recommendations

jkoelker01 Novice
Currently Being Moderated

I have a question in terms of backup recommendations. I would like to know what others thoughts are on doing backups via the Dump command straight to a tape drive versus using NDMP to a third party software for the backups. I currently and always have done the NDMP route but as we grow and add more data my backups on occasion aren't completing with the backup schedule which is 7pm - 7am. Depending on the amount of data change rate it just doesn't happen sometimes. So that leads to my question, I know with the third party software I am able to do restores of individual files, vmdk's, etc.... and I believe with the Dump that isn't true but I'm not sure, which route am I better to go with. I have a second SAN which I snapmirror too offsite. I also do VSC backups of all the virtual servers and have snapshots of my cifs. So what opinions is anyone able to offer in terms of using the Dump command or NDMP to third party software. I know NDMP is much nicer in terms of restores and having a gui interface but if the backups aren't finishing on time sometimes, I don't care about that. Can someone confirm whether I am able to restore individual vmdk's or not from the dump backups? Any help would be greatly appreciated.


I currently have a FAS2020 with version 7.3.6 with a single controller. I will be moving to a FAS 2240-2 shortly with version 8.1.1.


Thanks in advance.

  • Backup Recommendations
    jkoelker01 Novice
    Currently Being Moderated

    Any recommendations or insight are greatly appreciated.

    • Re: Backup Recommendations
      scottgelb Hall of Fame Certified Grand Marshal
      Currently Being Moderated

      ndmp uses dump but automates tape changers and also provides direct access restore... Unless a small data set, I would not use dump.  You would need a tape library in stacker mode or would have to manually swap tapes in the drive for the dump if it exceeds a tape...and also need to manually load and unload before and after.  You also won't have a catalog so need to know what to restore.  You can specify a file name to restore but it would have to scan ALL tapes in the backup prior to restore to get the image... DAR (direct access restore) in ndmp software takes you right to the tape that has the data.  I would recommend ndmp software for management, catalog, library control, direct access restore, share tape drives with other devices if on a shared switch, etc.

More Like This

  • Retrieving data ...


  • Correct Answers - 10 points
  • Helpful Answers - 5 points