I'm installing a new FAS2040 and I'm trying to attch the onboard fibre ports through a single Brocade switch to an ESX host. I have configured the controllers in single mode and set the nodename on both controllers to match. I have also set the FC ports as targets. I have left the speed settings on the ports to auto-egotiate, but on the switch they connect at "N2" where the ESX host connects at "N4". They are zoned to each other, but the FAS2040 sees no intiators when I run "fcp show initiators". I'm thinking I should try to hard set the speed on the array and the switch to 4Gb to see if that corrects the issue, but if it does not, I'm not sure where to go next.