I recently got an old NetApp Fas3050 for my homelab and to learn about NetApps. I received two heads and two disk shelves. When I received it, it took me quite some time to figure out the wiring of the cabling between heads and shelves. I finally got it working and created a LUN on it. But for some DR / replication testing I decided I want to make two separate NetApps of it. So I used this instruction to create a single cabled unit: http://www.flickr.com/photos/60938528@N00/5184699197/
Unfortunately now the unit won't boot anymore. I receive the errors below. Is this because the unit misses the old config and can I simply reset it (how?). Or is the cabling for the single unit cabling still wrong?
Looks like a disk ownership issue.
Did you get the right disks/shelves separated ?
Boot and hit ctrl-C when it says to get the boot menu.
At the boot menu (options 1-5) enter in '22/7' for the Secret boot menu.
You'll get to explore the maint mode boot menu, including things like unassigning and reassigning your disks.
I hope this response has been helpful to you.
At your service,
(P.S. I appreciate points for helpful or correct answers.)
You may also want to check the value of the pre boot environment
The contents of the variable might look like the following
Try adding that second connection you cabled up to the list and see if
that helps. This is
usually involved with adding new first disk shelves on new loops on a
but may be at play in your configuration.